Coduri de eroare Caterpillar® (CAT®) · Pe sistem
53 de coduri de eroare documentate pentru acest sistem. Alege codul de pe afișaj pentru diagnostic și piese.
A4:M1...
An error has been detected that may result in inaccurate guidance: measured blade dimensions do not agree with configured blade dimensions!
As400 (Pitch) …
Avoidance Zone areas are too far from the design surface and will not be drawn. Check your units or redesign the Avoidance Zone file.
Avoid Zone Entered
Corrupt file or data card
Data card full
File error while loading ...
Invalid GPS Configuration
Loading Data
Low Accuracy (GPS)
Low Accuracy (pitch)
No controls Data
No controls data is being received. Please check the cable connections
No Data
No data card
No data card present
No Design Loaded
No devices were detected on the CAN bus
No GPS Data (Right)
No GPS Receiver Data
No pitch sensor data is being received. Please check the cable connections
Not Enough Memory To Load The
Off Design
Off Grade
Old Position
Out of memory!
Out of the Auto Range
Part of the SVD design file is invalid
Read/write error
Reverting to factory default settings
Some of the required system devices are not responding
Some of the required system devices have old firmware versions
Some settings are missing or invalid, and will be reset to factory defaults
The current GPS Accuracy mode does not allow automatic controls
The design file could not be saved
The design you selected could not be loaded
The GPS receiver configuration has not been updated
The GPS receiver firmware is old. Upgrade to V1.00 or greater for correct operation.
The GPS receiver needs a configuration file
The reference surface list for this design could not be loaded
There is a problem with the data card - please insert a valid card. Check the program log for details.
The selected setting file could not be read
The selected setting file could not be saved
The selected settings file is invalid
The SVD file is an obsolete version. Please regenerate it using SiteVision Office v5.50
The valve speed cannot be updated because controls are not working
Unexpected error
V.Low Accuracy (GPS)
Vm410
WARNING: Your GPS base station coordinates have changed. Continued operation may give bad results.
Your GPS base station coordinates have changed
Your GPS receiver is not responding correctly
