Coduri de eroare CAT® — sistem AccuGrade® - CD700 Sistem de control al nivelării (GPS/ATS/Sonic/Cross Slope)

Check Arm Sensors

Check Boom Sensor

Check Bucket Sensor

Check Bucket Tilt Sensor

Check M/c Dimensions

Check Machine Type

Check Pitch Sensor

Check Stick Sensor

Corrupt file or data card

Data card full

Direction Unknown

Error, the Avoidance Zone areas are too far from the design surface and cannot be drawn. The design will be unloaded.

Error, the Avoidance Zone areas are too far from the design surface and cannot be drawn. The system will be shut down.

Error loading Avoidance Zone. The system will be shutdown.

File error while loading ...

Invalid GPS Config.

Invalid GPS Configuration

Invalid GPS Data

Loading Data

Low Acc. (No Bucket)

Low Accuracy (GPS)

Low Accuracy (Move)

Low Accuracy (pitch)

Moving Base

No Bases Found

No controls Data

No controls data is being received. Please check the cable connections

No Data

No data card

No data card present

No Design Loaded

No devices were detected on the CAN bus

No GPS Data

No GPS Data (Right)

No GPS Receiver Data

No GPS Right

No Pitch Sensor Data Is Being Received. Please Check The Cable Connections

Not enough memory to load the ...

Off Design

Off Grade

Old Position

Out of memory!

Out of the Auto Range

Parameter Value Error

Part of the SVD design file is invalid

Read/write error

Reverting to factory default settings

Search Failed

Software support option

Some of the required system devices are not responding

Some of the required system devices have old firmware versions

Some settings are missing or invalid, and will be reset to factory defaults

The current GPS Accuracy mode does not allow automatic controls

The design file could not be saved

The design you selected could not be loaded

The display configuration file could not be read

The GPS receiver configuration has not been updated

The GPS receiver firmware is old. Upgrade to V1.31 or greater for correct operation.

The GPS receiver firmware is old. Upgrade to V1.34 or greater for correct operation.

The GPS Receiver Firmware Is Old. Upgrade To V1.37 Or Greater For Correct Operation.

The GPS Receiver needs a configuration file

The GPS receiver needs a configuration file sent to it

The office has finished the file transfer. You may select a different design.

The office is transferring a file. Map recording has been paused and you cannot select a different design. Wait for the file transfer to finish or contact the office.

There are no appropriate settings files on the data card. Please insert a data card with settings files.

The reference surface list for this design could not be loaded

There is a problem with the data card - please insert a valid card. Check the program log for details.

The Selected Setting File Could Not Be Read

The Selected Setting File Could Not Be Saved

The selected settings file is invalid

The SVD file is an obsolete version. Please regenerate it using SiteVision Office V4.01.

The SVD file is an obsolete version. Please regenerate it using SiteVision Office v4.01 or later

The Svd File Is An Obsolete Version. Please Regenerate It Using Sitevision Office V5.50

The valve speed cannot be updated because controls are not working

Unexpected error

V. Low Accuracy

V. Low Accuracy (GPS)

Vm410...

WARNING: The display configuration was created by V1.50 software. The machine and receiver measurement method has changed since then.

WARNING: The selected settings file is for a different machine type. Do you want to continue?

WARNING: Your GPS base station coordinates have changed. Continued operation may give bad results.

Your GPS base station coordinates have changed

Your GPS receiver is not responding correctly